2-1/2" ID Boat Lift Split Cable Winder
The 2-1/2" ID (2-15/16" OD) Boat Lift Split Cable Winder is designed to fit standard 2-1/2" ID (2-15/16" OD) boat hoist drive pipe. Constructed from durable 6061-T6 marine-grade aluminum, the split design allows for easier installation without requiring removal of the drive pipe.
Each side holds up to 14' of cable and accommodates steel cable up to 5/16" in diameter. Precision-machined grooves run in opposite directions from the center starting point, helping guide the cable evenly across the winder. This design helps keep the cable straight, maintain its shape, and reduce unnecessary wear for longer cable life.
The cable winder can be used in center-mounted drive pipe configurations where cable is routed through four pulleys, as well as side-mounted drive pipe configurations where cable runs through two pulleys on one side and directly to a sling or cradle from the pipe.
Designed to fit BH-USA dual pipe supports.
Inside Diameter: 2-1/2"
Outside Diameter: 2-15/16"
Material: 6061-T6 Marine-Grade Aluminum
Cable Capacity: Up to 14' per Side
Maximum Cable Diameter: 5/16"
Design: Split for Easier Installation
Compatibility: Standard Boat Hoist Drive Pipe & BH-USA Dual Pipe Supports
Important: Installing cable winders increases the outside diameter of the drive pipe and will reduce the rated lifting capacity of the hoist and motor.
2-1/2" ID Boat Lift Split Cable Winder
The 2-1/2" ID (2-15/16" OD) Boat Lift Split Cable Winder is designed to fit standard 2-1/2" ID (2-15/16" OD) boat hoist drive pipe. Constructed from durable 6061-T6 marine-grade aluminum, the split design allows for easier installation without requiring removal of the drive pipe.
Each side holds up to 14' of cable and accommodates steel cable up to 5/16" in diameter. Precision-machined grooves run in opposite directions from the center starting point, helping guide the cable evenly across the winder. This design helps keep the cable straight, maintain its shape, and reduce unnecessary wear for longer cable life.
The cable winder can be used in center-mounted drive pipe configurations where cable is routed through four pulleys, as well as side-mounted drive pipe configurations where cable runs through two pulleys on one side and directly to a sling or cradle from the pipe.
Designed to fit BH-USA dual pipe supports.
Inside Diameter: 2-1/2"
Outside Diameter: 2-15/16"
Material: 6061-T6 Marine-Grade Aluminum
Cable Capacity: Up to 14' per Side
Maximum Cable Diameter: 5/16"
Design: Split for Easier Installation
Compatibility: Standard Boat Hoist Drive Pipe & BH-USA Dual Pipe Supports
Important: Installing cable winders increases the outside diameter of the drive pipe and will reduce the rated lifting capacity of the hoist and motor.
